Zipper Pull using 18 AWG wire

### Summary
Replacement zipper pull, requires vitamins:

* 18 AWG galvanized wire
* 6mm M2 machine screw + nut

### Notes
This pull replaces one from a relatively small zipper that is really tough to pull and needs to be very strong.

To make your own you'll have to feed a short length of 18AWG wire through the zipper and then bend it with fine pliers until you get the shape right so that it will seat in the wire channel of the pull. When it's close sandwich the two sides together and tighten, it should come together nicely. The channel is 1.5mm in diameter, in order to fit 18AWG wire, which is ~1mm diameter with room for not perfectly straight wire. So far the wire hasn't budged.

https://a360.co/2SbE74T