Thingiverse
Ziptie anchor mount
von Bunnykillcz
7
Downloads
6
Likes
0
Makes
**Small ZIPTIE ANCHORs**
I was in need of a small ziptie anchor, a mount for a ziptie, but in a place I could not use any screws, since the place was not thick and the other side was supposed to look pretty, so I came up with these small simple things
One is supposed to go on a flat surface _(glued on)_, the other one goes into a corner _(glue it, baby)_
It's just a simple thing and print settings really depend on the material you choose to use.
I used PLA and printed it on default settings. For my purposes it's fine now.
Printing 10 corner pieces and 10 flat pieces takes about 2 hours total.
_(print them laying on side for better performance)_
I was in need of a small ziptie anchor, a mount for a ziptie, but in a place I could not use any screws, since the place was not thick and the other side was supposed to look pretty, so I came up with these small simple things
One is supposed to go on a flat surface _(glued on)_, the other one goes into a corner _(glue it, baby)_
It's just a simple thing and print settings really depend on the material you choose to use.
I used PLA and printed it on default settings. For my purposes it's fine now.
Printing 10 corner pieces and 10 flat pieces takes about 2 hours total.
_(print them laying on side for better performance)_
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
