Thingiverse
ZMR250 Mobius Mount
door marcotheboy
6
Downloads
5
Likes
0
Makes
Three Mobius mounts for ZMR250.
Angled at 0 degrees, 10 degrees and 20 degrees.
The mount is mounted directly to the frame and should be printed in flexible filament.
I have tested it and the video has no jello.
(I don't know how it would be if you print it in PLA or ABS.)
The velcro strap goes through the ZMR250 top plate, so it holds down both the Mobius and the mount.
The stock M3x6 screws are just too short, so you should use M3x8 (or M3x10 to be safe).
(The thickness of the mount base is 2mm.)
Angled at 0 degrees, 10 degrees and 20 degrees.
The mount is mounted directly to the frame and should be printed in flexible filament.
I have tested it and the video has no jello.
(I don't know how it would be if you print it in PLA or ABS.)
The velcro strap goes through the ZMR250 top plate, so it holds down both the Mobius and the mount.
The stock M3x6 screws are just too short, so you should use M3x8 (or M3x10 to be safe).
(The thickness of the mount base is 2mm.)
marcotheboy publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
