Thingiverse
ZOHD Drift Canopy: Lightweight Vasemode
door t4obrien
31
Downloads
22
Likes
3
Makes
My friend lost his ZOHD Drift's front canopy– so I designed him one to be 3D printed, _obvi_
The original one, even when printed with 1 perimeter and minimal infill, was still far too heavy and so strong it was vast overkill. So I redesigned it to be printed, NACCA duct and all, in vase-mode / spiralize-outer-contour (in cura).
You can use heat up a paperclip or use soldering iron to melt-off the inside wall for an ultra lightweight canopy that's still plenty strong. Print it with a transparent HTPLA+ for that great translucent look.
[](https://gfycat.com/UnawareDamagedKob)
### Post your make!
[](https://www.thingiverse.com/thing:4840976/make)
Please post 'em! Really! Take a quick cameraphone photo of your print in all its glory and show it off! Plus it really helps get this design out there to the world.
### Message me on [discord](https://
The original one, even when printed with 1 perimeter and minimal infill, was still far too heavy and so strong it was vast overkill. So I redesigned it to be printed, NACCA duct and all, in vase-mode / spiralize-outer-contour (in cura).
You can use heat up a paperclip or use soldering iron to melt-off the inside wall for an ultra lightweight canopy that's still plenty strong. Print it with a transparent HTPLA+ for that great translucent look.
[](https://gfycat.com/UnawareDamagedKob)
### Post your make!
[](https://www.thingiverse.com/thing:4840976/make)
Please post 'em! Really! Take a quick cameraphone photo of your print in all its glory and show it off! Plus it really helps get this design out there to the world.
### Message me on [discord](https://
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
