Thingiverse
Zoku Popsicle stick
door baughbl
1
Downloads
1
Likes
0
Makes
Zoku popsicle stick replacement. It has a threaded 1/4 course nut to insert into to allow use of the puller.
1/4 nut is .44 inches (11.1mm), and .2 inches high (5mm height). Use slicer to create a stop/pause at the 15mm height or so, and insert the nut. Continue printing.
I printed using PETG - no supports. I used PETG for food safety.
Layer height @ .2, and 30% infill.
1/4 nut is .44 inches (11.1mm), and .2 inches high (5mm height). Use slicer to create a stop/pause at the 15mm height or so, and insert the nut. Continue printing.
I printed using PETG - no supports. I used PETG for food safety.
Layer height @ .2, and 30% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!