ZSW Indra Handguard

This handguard is fully floated. there is no forward collet to hold the barrel. in my testing this is a non issue however if you abuse the blaster that is outside my own testing parameters.

This is a pre-release version of my Indra front end integration and full float handguard. picatinny top and bottom rails, MLOK side. MLOK slots may be too thick still, will be brought to final dimensions for v1.1

This ought to print with no supports. there is a portion at the top of the rear segment that may fail. it doesn't matter.

I have cut the part in to two segments to fit the z axis of my ender 3v2 though if there is demand for it I could add the single part model. You need something on the order of 300mm z for that. The cut model provided uses small segments of filament as guide pins. I would recommend gluing the halves together to create one contiguous piece though it probably isn't strictly needed.