Thingiverse
ZTE H1600 Wall Mount
von CraftyCraftsman
1
Downloads
1
Likes
0
Makes
Wall mount for ZTE-H1600 Wi-Fi Modem Router.
This is the standard router supplied by Superloop in Australia https://ztemobiles.com.au/zte-h1600/
The spacer isn't needed unless you need to clear a doorframe. It could also be stretched to be shallower or deeper as required to clear other obstacles.
Designed to be printed without supports.
The base can be printed as is.
The top needs to be rotated 180 degrees and printed upside down.
The spacer needs to be laid flat on the print bed with the screw holes vertical.
I printed on an Ender S3 v2, 10% infill and all standard settings for bed and extruder temp etc.
Feel free to send a tip if this mount has helped you out!
This is the standard router supplied by Superloop in Australia https://ztemobiles.com.au/zte-h1600/
The spacer isn't needed unless you need to clear a doorframe. It could also be stretched to be shallower or deeper as required to clear other obstacles.
Designed to be printed without supports.
The base can be printed as is.
The top needs to be rotated 180 degrees and printed upside down.
The spacer needs to be laid flat on the print bed with the screw holes vertical.
I printed on an Ender S3 v2, 10% infill and all standard settings for bed and extruder temp etc.
Feel free to send a tip if this mount has helped you out!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!