Thingiverse
Zynthian Case
von Axeman72
35
Downloads
18
Likes
0
Makes
This is a fully printable case for the fantastic Zynthian project:
http://zynthian.org/
All visible parts are rotated so that the external side is the first layer (on a glass bed this make a fantastic look).
Overhang are less than 45° so all parts should print without support.
You can thread (M4) holes on the tabs in left and right side, or glue nuts in place.
(Yes, I know, screw holes on the back panel are almost out of the tabs... I'll fix that ASAP)
http://zynthian.org/
All visible parts are rotated so that the external side is the first layer (on a glass bed this make a fantastic look).
Overhang are less than 45° so all parts should print without support.
You can thread (M4) holes on the tabs in left and right side, or glue nuts in place.
(Yes, I know, screw holes on the back panel are almost out of the tabs... I'll fix that ASAP)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
