007特工平板支架（Tablet Stand）

【007特工平板专属支架】11 寸以下平板通用 ；6 档可调节视角，观影 / 办公 / 创作全适配 ；隐藏式带盖笔槽，收纳手写笔不丢件 ；双侧可挂载手机支架，轻松实现双屏协同 ；后置大容量收纳仓，可放充电器 / 充电宝 ；右下角解压 OK 按键，轴体手感清脆解压 ；整体尺寸：322×130×155mm，科幻造型 + 实用功能拉满；可放平板的尺寸为长度是180mm~250mm之间，厚度9毫米以下的；Universal for tablets under 11 inches; 6 adjustable viewing angles, perfect for watching videos, working and drawing creation; Hidden covered stylus slot to store your pen and avoid loss; Dual side mounts for phone holders to easily realize dual-screen collaboration; Large rear storage compartment for chargers and power banks;Stress-relief OK button at the bottom right with crisp tactile shaft for satisfying decompression; Overall dimensions: 322×130×155mm, futuristic design packed with all practical functions; Fits tablets with length ranging from 180mm to 250mm and thickness under 9mm; Support me for free；注意事项:调节支架角度的时候，请使用左右两边的旋钮同时调节，一共6个角度，请勿在单独调节一边，避免损坏平板；打印前请清洁打印板，做好耗材烘干；按钮点击器需要自行购买一个键盘轴体，若不需要则可以使用胶水固定死；请按说明书顺序安装，过程需要用到胶水，推荐使用速干胶水；支架活动部分的耗材推荐使用petg；When adjusting the angle of the stand, turn the knobs on both the left and right sides simultaneously.There are six adjustable angles in total. Do not adjust only one side, as this may damage your tablet.Clean the print bed and thoroughly dry the printing materials before printing.A keyboard switch needs to be purchased separately for the clicker button. If you do not need the pressing function, you may secure it permanently with glue.Assemble the stand following the steps in the instruction manual. Glue is required during assembly;instant glue is recommended.PETG filament is recommended for all movable parts of the stand.