Thingiverse
050 Diglett
von bradicai
21
Downloads
13
Likes
0
Makes
Pokemon 050 Diglett Dual extrusion Low Polygon
Prints in one piece without supports(a bit precarious). Included a single extruder version.
You can print in 1 piece if you insert a pause between nose and rocks, either in a slicer or manually(not recommended). or you could print the rocks as a separate piece but thats less fun.
I Like to print BIG so the IRL picture is 10cm tall(not big, but scaled to the other i have which are bigger) but I printed with 3 shells(0.4W 0.2H) and infill. And I haven't printed the single color version but it should print the same just without extra walls between the parts
Prints in one piece without supports(a bit precarious). Included a single extruder version.
You can print in 1 piece if you insert a pause between nose and rocks, either in a slicer or manually(not recommended). or you could print the rocks as a separate piece but thats less fun.
I Like to print BIG so the IRL picture is 10cm tall(not big, but scaled to the other i have which are bigger) but I printed with 3 shells(0.4W 0.2H) and infill. And I haven't printed the single color version but it should print the same just without extra walls between the parts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
