Thingiverse
090 - Shellder
von erikfurton
26
Downloads
25
Likes
0
Makes
Assemble your own Shellder!
Each component has a flat surface you can print on. The two purple pieces are pretty tricky, and unfortunately require quite a bit of supports.
Tolerances and allowances are made for the FashForge Finder printer. Unfortunately not all printers are the same, so some of your components might be too loose or tight.
Special thanks to http://roestudios.co.uk and Nintendo
https://www.youtube.com/watch?v=6KNWvqXFZOQ
Each component has a flat surface you can print on. The two purple pieces are pretty tricky, and unfortunately require quite a bit of supports.
Tolerances and allowances are made for the FashForge Finder printer. Unfortunately not all printers are the same, so some of your components might be too loose or tight.
Special thanks to http://roestudios.co.uk and Nintendo
https://www.youtube.com/watch?v=6KNWvqXFZOQ
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!