Thingiverse
110 Quadcopter/Drone Frame
door xlitec13
11
Downloads
13
Likes
0
Makes
A minimal size 3D printable frame for 3 inch blades (can't go smaller than 110mm for clearance reasons).
The frame is designed to fit most 1102-1407 brushless motors and has built in 20mm mounting holes for the electronics. The printed frame is 11-25g, depending on perimeter settings, infill settings, and filament type.
There is no battery mounting hardware designed in.
This frame is untested as I don't have the parts for a 3" quadcopter. If you do print and build on this frame, let me know how well it goes!
The frame is designed to fit most 1102-1407 brushless motors and has built in 20mm mounting holes for the electronics. The printed frame is 11-25g, depending on perimeter settings, infill settings, and filament type.
There is no battery mounting hardware designed in.
This frame is untested as I don't have the parts for a 3" quadcopter. If you do print and build on this frame, let me know how well it goes!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
