160mm Shelf Riser

I wanted to declutter my desk so I choose to raise my Computer onto a shelf using these risers and about a 9 inch wide wood piece. The file is just the risers, I needed 2 for adequate support, depending on wood thickness / strength you may want to print 3 for center support. Wood shelf bottom starts 130mm this is based on height restriction due to shelving, this can be scaled as needed. Each bracket has 3 recessed screw holes based on 0.25" shaft and chamfer sized well for 1.25" wood screws that I used. Assembly is print how many brackets you need, mark on your board for predrilling, predrill, mount brackets and good to go! I printed PET=G HF for strength, but PLA may be sufficient depending on load.