Thingiverse
16mm Power Switch Button Mount
by Quittik
0
Downloads
0
Likes
0
Makes
Print face down so there is no need for supports.
Just a very basic 16mm power button mount to put magnets, tape etc on to mount a power button. If you need anything just ask. about a 20-30 minute print.
Just a very basic 16mm power button mount to put magnets, tape etc on to mount a power button. If you need anything just ask. about a 20-30 minute print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
