199c Camera Canopy

This is just a lite and simple canopy for the 199c canopy inspired by Jakob_Duus' design.

Fixed some sections so the V2.1 could fit properly. It has a slightly lighter design but should mostly depend on your print settings. I also lowered the angle as I primarily fly in my room - this is set to 23 degrees.

The .f3d file is included which also has the camera mock-up and the canopy itself.

Update [18/01/2024]: the V2 variant got some minor changes that made it easier to remove the camera from the canopy, reduced a tiny bit of weight, and made removing supports easier.

Update [1/07/2024]: V3 removed one more little section. This reduced the weight a bit and makes it easier to remove the camera from the canopy. Added some top corner guards too for its pcb and the V3_Fin version has a tiny fin for added protection.