1x20 Kill Flash / Scope Protector

I have designed this Killflash to act as a disposable scope protector as well as acting as a kill flash.

The Killflash is a secure press fit but is removable for replacements. If you are worried about it falling out, you can use a scope cover to trap the kill flash in place.

I have modelled the killflash on my Vector Optics Maverick IV Mini Red Dot Sight. However it should fit on most 20mm diameter red dots.

I have used the hex design from my LPVO killflash (https://cults3d.com/en/3d-model/game/lpvo-kill-flash-scope-protector) landing at a hex depth of 8mm. The testing used a 2.2J sniper with 0.48g BB's point blank, with both designs failing on the forth shot in the same area!
Testing is available: https://imgur.com/a/HaxcKCz

I would not recommend up-scaling the model due to the large size of the hex, however down-scaling should work with smaller scopes.

Disclaimer; Always wear appropriate eye protection when handling airsoft replicas. Replace the protector after being