Thingiverse
Original Prusa I3 MK2 PSU Top Cover
by BeardedMaker
23
Downloads
10
Likes
0
Makes
Top cover for the PSU of the Prusa I3 Mk2(S)
I was missing a top cover for my Prusa I3 Mk2s
So I designed one that is aesthetically pleasing following the shapes of the original designs.
For mounting you can just slide it over the top of the PSU.
A more permanent solution would be to use some double sided tape on the inside of the top.
Or drill some holes on the top where the screws of the PSU are currently located.
It can be printed in PLA or ABS, the PSU does get a bit warm, but I
I was missing a top cover for my Prusa I3 Mk2s
So I designed one that is aesthetically pleasing following the shapes of the original designs.
For mounting you can just slide it over the top of the PSU.
A more permanent solution would be to use some double sided tape on the inside of the top.
Or drill some holes on the top where the screws of the PSU are currently located.
It can be printed in PLA or ABS, the PSU does get a bit warm, but I
Sign in to leave a comment
Sign in