Thingiverse
1/8" BSP Bowden connector mount
by frankvdh
4
Downloads
5
Likes
0
Makes
Made for the Precision Piezo hotend probe, but good to attach a Bowden coupler to any effector using M3 screws 25mm apart.
As for the original, use a heatgun to warm the plastic, then screw the coupler.into the mount. Be careful not to warp the mount.
The hole in the middle is 9.2mm diameter, which is good for my Bowden coupler, which I believe has a BSP 1/8" thread.
As for the original, use a heatgun to warm the plastic, then screw the coupler.into the mount. Be careful not to warp the mount.
The hole in the middle is 9.2mm diameter, which is good for my Bowden coupler, which I believe has a BSP 1/8" thread.
Sign in to leave a comment
Sign in