Thingiverse

CR-10 E3D Carriage Mount w/ Additional Mounting Point

by ThermoDynamicEntropy

62 Downloads

36 Likes

0 Makes

Download Model

Hi, all. This is a remix for the CARRIAGE MOUNT ONLY of Bandanam4n's E3D V6 mount. The original mount only had 2 screws securing it to the printer's gantry/carriage on the bottom of the mount and two screw holes at the top for securing the E3D. This would cause angular pressure to be applied to the the carriage mount, and caused mine to sag a bit. So if you're also having a sagging hot-end problem, or just want a bit of extra support this remix is the one for you.

This mount adds an additiona

Source

Thingiverse

Comments