Handle for using a Vise as a Drill Press Vise

Sturdy little handle for using a vise as a drill press vise.

For smaller hands.
Prints without support.
Use many outer shells for increased strength.

Additional needed parts:
Vise with 16mm rod.
3x SPAX Screw 3x30mm
4x SPAX Screw 2.5x25mm
Optional: Small Strip 3M VHB (Put the glue tape on one side of the metal rod of the vice. Press the rod with an oscillating movement into its hole for a strong fit after tightening the screws.)