Thingiverse

Y-Axis Belt Clamp for ANET A6 or A8

by kkrebs76

114 Downloads

70 Likes

0 Makes

Download Model

axis clamp belt clamp Belt Tensioner clamp y-axis axis clamp belt clamp Belt Tensioner clamp y-axis axis clamp belt clamp Belt Tensioner clamp y-axis axis clamp belt clamp Belt Tensioner clamp y-axis axis clamp belt clamp Belt Tensioner clamp y-axis

An improved way to line up, level up and clamp the Y-Axis belt to the H-Frame. Two identical parts pair up allowing you to secure and tension the Y-Axis belt to the H-Frame. 4 each button head 4mm x 25mm Lg screws and two each 4mm x 8 Lg set screws are needed for this adaptation. The belts get pre-assembled to each block and then secured to the H-Frame. The set screw in the upper block is preset to a position approx 1-1.5 mm below flush face where the belt rests to secure that belt. Whe

Source

Thingiverse

Comments