Heated polycarbonate 3d printer enclosure

Simple enclosure for my Brenda 3d printer.
Should work for other printers as well.

printed parts:
-drillhelp, the hole is a bit closer to the edge (2.5mm) so the round edge of the extrusions stays visible.
-door parts
-lcd holder (doesn't fit perfectly but was good enough for me).
-IEC holder
-the atxboard is you use the board from https://www.staticboards.es/productos/atxboard/
I would advise to use different crimps as the provided solution is a bit high, I used a seasonic sfx 350 wa