Thingiverse
CR-10 Dual Z Pulley Setup
by StvPtrsn
314
Downloads
164
Likes
0
Makes
Update: I have completely redesigned this and posted as a new project https://www.thingiverse.com/thing:2829855
As requested here are the files for the dual Z setup I recently set up. One of my main design goals was to not use any set screws. Here are the specific parts I used.
Note: I used the factory Dual Z setup as a base, therefore a right side lead screw bracket wasn't needed.
T8 600mm 3D Printer Stainless Steel Lead Screw Coupling Shaft Mounting Bearing
Link: http://r.ebay.co
As requested here are the files for the dual Z setup I recently set up. One of my main design goals was to not use any set screws. Here are the specific parts I used.
Note: I used the factory Dual Z setup as a base, therefore a right side lead screw bracket wasn't needed.
T8 600mm 3D Printer Stainless Steel Lead Screw Coupling Shaft Mounting Bearing
Link: http://r.ebay.co
Sign in to leave a comment
Sign in