Thingiverse
Taz Magnetic Bed System
by jaln
10
Downloads
8
Likes
0
Makes
(parts are listed at end of this)
I have been using a auto level probe for while. At first I clamped a .4" thick sheet of aluminum with a 1mm sheet of PEI over it, using 12 clamps to clamp the the glass bed.
It worked okay but was a pain because of the clamps and the center of the PEI was a little flexible.
For the most part, the nozzle prevented any serious bow. I had to use a large 18mm inductive probe because the aluminum cuts the probe sensing gap in half. Then I tried a piece of steel
I have been using a auto level probe for while. At first I clamped a .4" thick sheet of aluminum with a 1mm sheet of PEI over it, using 12 clamps to clamp the the glass bed.
It worked okay but was a pain because of the clamps and the center of the PEI was a little flexible.
For the most part, the nozzle prevented any serious bow. I had to use a large 18mm inductive probe because the aluminum cuts the probe sensing gap in half. Then I tried a piece of steel
Sign in to leave a comment
Sign in