Thingiverse
CR10 S5 glass holder block
by Bee69
33
Downloads
11
Likes
0
Makes
Hi Guys.
I made these so there is no gap and can not be over tightened and damage the glass. All that is needed is 6 30mm bolts and 6 T nuts. I've used two in the front and two in the rear plus one on ether side.
I made these so there is no gap and can not be over tightened and damage the glass. All that is needed is 6 30mm bolts and 6 T nuts. I've used two in the front and two in the rear plus one on ether side.
Sign in to leave a comment
Sign in