Thingiverse
Electronics
Go to Model
3 in 1, mains power cable assembler
58
Downloads
45
Likes
0
Makes
Warning : check local regulations before use,
use correct filament type,
be sure to solder all wires together so there is most possible distance to the other phase or earth.
use thinn EPOXY type to fill the case all the way to the level where the top goes,
while wet, press the top part into the hole, all the way, wipe epoxy off while it hardens.
make at own risk, use at own risk, if you are new to electronics or soldering, this is NOT a project for you.
use correct filament type,
be sure to solder all wires together so there is most possible distance to the other phase or earth.
use thinn EPOXY type to fill the case all the way to the level where the top goes,
while wet, press the top part into the hole, all the way, wipe epoxy off while it hardens.
make at own risk, use at own risk, if you are new to electronics or soldering, this is NOT a project for you.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
