Thingiverse
Base Fan Duct for Anycubic Kossel Linear Plus
by fastryan
52
Downloads
39
Likes
0
Makes
The motors on my Anycubic Kossel Linear Plus were quite hot to the touch, so I added a fan to cool things down under the bed. I doubt this is necessary, motors can run very hot without any loss in performance or lifespan. Fan just plugs into the "Fan 1" socket on the Trigorilla board.
The fan I used already had a housing covering ~20% of one side, so this duct is shaped to match that. This is controlled by the "fan_opening" variable in the OpenSCAD file, and I've included 2 versions of the ST
The fan I used already had a housing covering ~20% of one side, so this duct is shaped to match that. This is controlled by the "fan_opening" variable in the OpenSCAD file, and I've included 2 versions of the ST
Sign in to leave a comment
Sign in