Thingiverse
Bowden clips CR-X Pre Extruder
by EastyUK
22
Downloads
16
Likes
0
Makes
This is a clip that slips onto the default housing of the CRx left side to help the bowden pipe align with the extrude unit.
A couple of other clips I printed online for the bowdens were to tight for my tubes. They are 4.0mm measured. So if yours are a little smaller you may need to scale the tube retainer down a little. I left it as free as possible not to compress the tube at all.
V1.1 Iteration
Updated with opening on the side, as the tube wants to generally lift up.
Hole size
A couple of other clips I printed online for the bowdens were to tight for my tubes. They are 4.0mm measured. So if yours are a little smaller you may need to scale the tube retainer down a little. I left it as free as possible not to compress the tube at all.
V1.1 Iteration
Updated with opening on the side, as the tube wants to generally lift up.
Hole size
Sign in to leave a comment
Sign in