Thingiverse
PCB cable cover and fan housing for Geeetech Pro B
by wsoutter
4
Downloads
3
Likes
0
Makes
The PCB cabling harness on the Geeetech Pro B is very messy. Also the fan is very inefficient blowing across the PCB.
Therefore I created a cover that "clips" behind the PCB i.e. it uses the PCB to hold itself against the back strut. I also took advantage of a hole in the vertical strut - where you can push standard geeetech bolt (3mm) through to hold it in place.
The fan I used was not the standard Geeetech one, from a few posts I read, if you can cool the PCB more - you get better pr
Therefore I created a cover that "clips" behind the PCB i.e. it uses the PCB to hold itself against the back strut. I also took advantage of a hole in the vertical strut - where you can push standard geeetech bolt (3mm) through to hold it in place.
The fan I used was not the standard Geeetech one, from a few posts I read, if you can cool the PCB more - you get better pr
Sign in to leave a comment
Sign in