Thingiverse
3D-Printed Hovercraft
door Jetpilot212
1.2k
Downloads
1k
Likes
0
Makes
I got the idea to build a Hovercraft last year when I read an article about Hovercrafts. From then I studied the topic and wanted to build one for myself.
This is my third prototype because the other ones had some issues.
- They rotated around their own axis -> I could not control them
- They could not carry enough weight
- Small stones destroyed the propeller of the lifting motor -> I glued
two bicycle tubes under the base.
For the design I used Autodesk Inventor 2013 and my printer was the MakerBot Replicator. It took around 3-4 days to print the third Hovercraft.
The base is not printed because it would take way too long. And Styrofoam has the advantage that it swims when the engines fail. I also did not print the bicycle tubes because they have to be flexible and they must be one piece so that no air flows out to the sides.
The Hoveraft is lifted by two motors and it has one thrust motor. The power for the motors comes from three 2800 mAh Lipo batteries.
My p
This is my third prototype because the other ones had some issues.
- They rotated around their own axis -> I could not control them
- They could not carry enough weight
- Small stones destroyed the propeller of the lifting motor -> I glued
two bicycle tubes under the base.
For the design I used Autodesk Inventor 2013 and my printer was the MakerBot Replicator. It took around 3-4 days to print the third Hovercraft.
The base is not printed because it would take way too long. And Styrofoam has the advantage that it swims when the engines fail. I also did not print the bicycle tubes because they have to be flexible and they must be one piece so that no air flows out to the sides.
The Hoveraft is lifted by two motors and it has one thrust motor. The power for the motors comes from three 2800 mAh Lipo batteries.
My p
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
