Creality Cloud
Latch
von
0
Downloads
0
Likes
0
Makes
I made a latch, you can buy one in any local hardwarestore for about the same cost.Designing this was more fun. 1 screw is needed for assembly.Printing:4 perimetersePrint vertical is best.ATTENTION:THERE ARE 2 DIFFERENT TYPES
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
