3D Printed Mini Pinball V2

Update 14/07/25: Added the table, split into two parts (2_Parts_A & B). They measure 160x154mm and 160x129mm respectively.... OK. Second attempt. Did I learn anything? Nope :) To be fair, I did get rid of the plastic springs and worked on improving the flipper and plunger mechanism. if you are lucky and possess the same size springs or small elastic bands that I based my changes on, then awesome, as I think it is a noticable improvement. Unfortunately the pens I salvaged the springs from were not branded, as in, I was only allowed (by the better half) to dissassemble the generic cheap freebie click pens that are given away by local business. So I can't point you to a particular make but in my investigations, I found that there were only two variations around (spread across about the 10 pens I tested) and they were the 20mm, which works a treat, and the 30mm which is too big. You could try snipping them down I guess. The elastic band method also works better than I expected, but is