Thingiverse
3D printer Bedlevel Tuning
von LowRider
17
Downloads
8
Likes
0
Makes
This is a single layer model in 0,2mm layer thickness.
Slice the stl at 0,2mm to trim the bedleveling with the knobs or with the Z offset babystepping during the print of this file.
Don't use skirts or brims or the part will not slice. (gets too big for the printbed)
Slice the stl at 0,2mm to trim the bedleveling with the knobs or with the Z offset babystepping during the print of this file.
Don't use skirts or brims or the part will not slice. (gets too big for the printbed)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
