3D Printer Electronics Enclosure

Note, The parts will load inverted, please flip 180deg before printing.

Rear mounted Electronics enclosure suited for CoreXY 3D printers. Was made to mount onto a rear panel ply or in my case some 4mm Aluminium Composite panel. The out side edge is recessed to allow a cover to be screwed in place. The 8 Parts are made up of a corner model and the 4 side piece variants can be selected to suit your setup. The is a blank side, a perforated side for cooling and a part perforated part 240/120v plug & master switch cutout.
You will require 50-55mm M3 (3mm) metric standoffs easily available on ebay / bangood / aliexpress etc..The standoffs will hold the parts in place and the cover will screw into the open side of the standoffs.

The cover lid should be 350 x 350 mm square with a 50mm radius on the corners