Thingiverse
3D-Printer Enclosure Controller ESP32
von MarvinB
28
Downloads
23
Likes
0
Makes
This is my first large project.
## This project is fully open source and all files are available including 3d print files, pcb files and software.
PCB files and Firmware both for the display and esp32 can be found on GitHub.
With some notes about the components.
The GitHub repository can be found here:
https://github.com/MarvinBeym/3D-Printer_Enclosure-Controller_ESP32/
These are the 3D files for my self designed enclosure controller based on the esp32 micro controller.
What can it do?
(For more detailed information look at my github repo)
Control 2x 4-Pin pwm fans
Read 2x DHT22 humidity/temperature sensors
It uses a Nextion NX4832T035 3.5inch 480px320p color touch TFT display
to display all values and make it possible to change them
There is also a webinterface made with ESPUI
It also features WifiManager to make it easy to setup a wifi connection with your homes network.
You can control 1 output using a relay to switch 12v (like 12v white led strip)
You
## This project is fully open source and all files are available including 3d print files, pcb files and software.
PCB files and Firmware both for the display and esp32 can be found on GitHub.
With some notes about the components.
The GitHub repository can be found here:
https://github.com/MarvinBeym/3D-Printer_Enclosure-Controller_ESP32/
These are the 3D files for my self designed enclosure controller based on the esp32 micro controller.
What can it do?
(For more detailed information look at my github repo)
Control 2x 4-Pin pwm fans
Read 2x DHT22 humidity/temperature sensors
It uses a Nextion NX4832T035 3.5inch 480px320p color touch TFT display
to display all values and make it possible to change them
There is also a webinterface made with ESPUI
It also features WifiManager to make it easy to setup a wifi connection with your homes network.
You can control 1 output using a relay to switch 12v (like 12v white led strip)
You
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
