Thingiverse
3D Printer frontpanel / full graphic smart controller case
von robcreate
2
Downloads
2
Likes
0
Makes
A housing for the reprapdiscount full graphic smart controller of my SparkCube.
It features:
* a hole for three car-fuses (e.g. 2x Hotend, 1x Bed)
* two holes for LEDs (ATX-Power, Power On by RAMPS)
* a hole for a stop button
* a hole for a switch to turn the printer on (enabling the ATX power supply)
I screwed it together by screwing the screws direct into the plastic
It features:
* a hole for three car-fuses (e.g. 2x Hotend, 1x Bed)
* two holes for LEDs (ATX-Power, Power On by RAMPS)
* a hole for a stop button
* a hole for a switch to turn the printer on (enabling the ATX power supply)
I screwed it together by screwing the screws direct into the plastic
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
