Thingiverse
3d printer level test and stringy test
door pka4bu
2
Downloads
0
Likes
0
Makes
Two tests.
one is 0.4mm thick dots across 6in deep and 8inch wide area.
print at 0.2mm layer, and check for how nicely the dots lay down.
Adjust height where layers are too thin or thick.
Second one is a stringy tower.
print start at you default speed, temp, and layer ht, bed temp etc.
adjust parameters until you get a setting that is best for your printer and filament.
one is 0.4mm thick dots across 6in deep and 8inch wide area.
print at 0.2mm layer, and check for how nicely the dots lay down.
Adjust height where layers are too thin or thick.
Second one is a stringy tower.
print start at you default speed, temp, and layer ht, bed temp etc.
adjust parameters until you get a setting that is best for your printer and filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!