Thingiverse
3D printer profile mount
von anoopkr
10
Downloads
4
Likes
0
Makes
The part is designed as a general hook for the 4040 profile with M5x16 bolts (just because I had them lying around) and M5 T-nuts.
Designed in Fusion 360.
No support is required to print.
The Case adapter which I used to hold Raspberry Pi is provided. I used some super glue to paste it onto the case. Dimensions are provided in the images so that you can add a custom dovetail to your part to be mounted.
I am also adding the modified part of the Raspberry Pi 4 case by Manuel (https://www.thingiverse.com/malolo/designs) for my custom mount.
{Note: I gave a tolerance of 0.2mm between my Pi case and this mount, which was a little bit on the loose side.}
Using it to mount raspberry-pi to the side of my Ender 3 V2.
Thanks to Manuel (www.thingiverse.com/malolo/designs) for the Pi case.
Designed in Fusion 360.
No support is required to print.
The Case adapter which I used to hold Raspberry Pi is provided. I used some super glue to paste it onto the case. Dimensions are provided in the images so that you can add a custom dovetail to your part to be mounted.
I am also adding the modified part of the Raspberry Pi 4 case by Manuel (https://www.thingiverse.com/malolo/designs) for my custom mount.
{Note: I gave a tolerance of 0.2mm between my Pi case and this mount, which was a little bit on the loose side.}
Using it to mount raspberry-pi to the side of my Ender 3 V2.
Thanks to Manuel (www.thingiverse.com/malolo/designs) for the Pi case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
