Thingiverse
3D Workshop Logo
by TroubleCoffe
39
Downloads
33
Likes
0
Makes
Needed a logo to put on the door; this is a bit of an experiment as I printed the first several layers at .25mm and the top at .2. However I miscalculated the top layer height by 1mm thus the entire lettering is silver... next one will be better. Printed with very minimal support
For additional details, I would recommend printing at .1mm
For additional details, I would recommend printing at .1mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
