Slicer Discord
3rdBall Bat – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

3rdBall Bat

0 Downloads
0 Likes
0 Makes
Zum Modell
This is a Small bat for a game that me and my friends created rules below. 3rd ball rules The game of third ball is a mixture between baseball wiffleball and cricket. the setup is similar to baseball. RULESNo Hard ThowingGet to touch point without getting hit with ball = run run = 1 point Setup Make a home base section this is where you will be batting Designate a touch point for scoring seperate into even teams Gameplay set up you feild with a pitcher ,chatcher , and depending on how many players you have put infeilders and outfeilders the baseball rules apply to the scoring / outs if you touch the ball with your bat you imedently start sprinting to the touch point if you are hit with the ball it is an out if you make it to the touch point that that is a run.Walks are considerd hits ( go to touch point) you can get out on walks. HAVE FUN!!!!!!!! (BALL IS UNDER GOOFY LITTLE BALL)
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen