4 Digit Code Lock Container

This is my original take on a classic. I designed and modeled all parts. It took me quite a few trials to get things the way I wanted but I think it's finally there. Like most others, the combination can be set during the assembly and changed later on if need be. I have included an AMS version and a single color per plate version as well as a stand. I used 2 nuts and bolts to hold the end caps on so the parts could be printed with as little support as possible. The inside dimensions of the storage is a 39mm X 74mm cylinder. I hope you enjoy this fantastic little lock cylinder. Hardware and Filaments are listed below. Update: Tweaks to the main body for extra strength. Assembly Instructions During plate one print (end caps) there is a pause at layer 27. You will need to insert an M3 nut into each cap and resume the print. Once all the pieces are printed, carefully clean off the supports on the main storage tube and the 4 number ring sleeves. Tip: you can run the M3 x 10 screws into the