4 inch speaker array

There are a lot of configuration options!!


Instructions:
- Vaneer
1. Use a laser or dragknife to cut the vaneer pieces with about a .2mm inset.
2. Superglue the vaneer to the speakerbox.
3. once the glue cures,, use a sander at 150 grit and be careful around the edges.
4. Sand to 600 grit and hit the edges.
5. oil / finish the vaneer.
6. Continue to electronics

- Wrap
1. use a dragknife like a CriCut or Cameo to cut out the wrap. I used a leather repair patch.
2. Apply pieces to the 3D print
3. Cut off anything that didn't fit in the indented grooves.
4. proceed to electronics

Electronics - See video

This will fit most 4" car speakers.
Here are some options:

JBL Stage 3427F
https://www.amazon.com/JBL-Stage3-Two-Way-Audio-Speakers/dp/B07P89J2GR/

Pyle
https://www.amazon.com/dp/B089QQSNDV


Here are some other parts:

Handle
https://www.amazon.com/Amerock-BP76312CS26D-Allison-Center-Center/dp/B004NJ26VK/

Bluetooth Radio (2 options)
https://www.a