49E Axis Sensor Mount

If you're like me and cannot find/acquire a STM32 bluepill board that works with FreeJoy, one of the only alternatives is using an Arduino "Pro Micro" (Arduino Leonardo) and the Arduino Joystick Library.

In my findings, the Pro Micro can only support one TLE5010/5011/5012 sensor without additional breakout boards, so we have to use linear hall effect sensors. I am using the 49E hall effect sensor. Also using the recommended cylindrical magnets.

You will have to drill the holes on the gimbal (the holes where the TLE sensors would mount) to fit m2 screws, maximum length 8mm
Solder wires to the pins and secure it with hot glue. If you don't want to drill out the holes, match your models with the picture and glue them into place. Do this for both the X and Y axis.
Should be pretty straightforward but leave a comment if you need help!