Thingiverse
5m cable management
door BGKDesign
0
Downloads
0
Likes
0
Makes
These two prints are my go-to for wire management and tidying up part movement. reduces stress and allows for a smoother run.
After a clean print, use a 1.75 fillament to pin it to the chain. works better than the original. The bowden tube angle is ideal because it keeps it low and reduces stress.
16min to print ready sliced on 5mpro.gcode only 8g of filament.
I could not find anything so I made my own. no support needed.
After a clean print, use a 1.75 fillament to pin it to the chain. works better than the original. The bowden tube angle is ideal because it keeps it low and reduces stress.
16min to print ready sliced on 5mpro.gcode only 8g of filament.
I could not find anything so I made my own. no support needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
