Hyper Realistic Pickle Magnetic Fidget Sliders

I couldn't decide If I liked the shorter or longer pickle slider better so I am sharing both to let you decide. The small pickle rides on a 1x5 strip of the standard 8x3mm magnets. The long pickle rides on the same magnets but on a 1x7 strip and the long throw is quite satisfying. If you use the attached 3mf file in bambu studio the printer will pause at layer 22, when printed at a 0.16mm layer height, at which point you put the magnets into the pickles. I have found it easiest to hold the magnets in a stack and put the stack into the hole and slide the stack off into the next hole. Place the magnets into one side of the pickle and FLIP THE STACK (Reverse the Polarity ) of magnets and repeat the process putting the magnets into the other half of the pickle. Resume printing and the printer will print over top of the magnets and you will be ready to fidget as soon as the model is done printing. If you have not printed a Fidget with embedded magnets yet and you are wondering about magnet