Thingiverse
8BitDo FC30 Controller Box
por Monkeysensei
12
Descargas
10
Likes
0
Makes
This is a protective case for the 8BitDo FC30 controller.
It snaps together really good. Great for travel, to keep the controller protected and turn off.
The desing also has modeled instructions to change modes in your FC30 controller, so you can alternate between PC,MAC, Android and Switch.
Also, there is groves so you can rest your celphone or table while you play on a table. Those groves also aling with the micro usb port, so you can charge your controller inside the case.
Once you open the case and use it as a stand for your celphone, you can snap the lid on the underside of the base.
I printed on a .12mm layer eight, with suports only for the bottom piece.
Tested in a Creality Ender 3
It snaps together really good. Great for travel, to keep the controller protected and turn off.
The desing also has modeled instructions to change modes in your FC30 controller, so you can alternate between PC,MAC, Android and Switch.
Also, there is groves so you can rest your celphone or table while you play on a table. Those groves also aling with the micro usb port, so you can charge your controller inside the case.
Once you open the case and use it as a stand for your celphone, you can snap the lid on the underside of the base.
I printed on a .12mm layer eight, with suports only for the bottom piece.
Tested in a Creality Ender 3
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
