Thingiverse
90 Degrees Cable Protector
by silv_r
23
Downloads
39
Likes
0
Makes
Couldn't find any 90 degrees cable protectors so I had to create one. Tested out on my wacom tablet, it sits nice and flush.
There is a locking system implemented. First insert the cable pointing up and then twist it into the hole. It should be a nice tight fit but your mileage may vary depending on the cable. Because of this lock are supports needed on the inside.
There is a locking system implemented. First insert the cable pointing up and then twist it into the hole. It should be a nice tight fit but your mileage may vary depending on the cable. Because of this lock are supports needed on the inside.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
