Thingiverse
9G Servo Popup Frame Mount
von zoomer2
3
Downloads
3
Likes
0
Makes
The 9g Servo Popup Frame Mount
This servo mount is similar to my original pop up mount but in this case it combines the Popup feature within a complete assembly which fits into a flush mount glued between adjacent wing ribs and is suitable for deeper pockets.
It is designed around the Towerpro 9g SG90 servo.
As with the original mount, if a servo needs to be replaced, or the servo arm needs to be repositioned then it can be tilted up for access.
The whole assembly fits snugly into the mounting frame and the servo can then be replaced by simply removing the 2, M2 clamp screws, tilting the servo assembly upwards and removing the servo.
The pocket depth can be greater than 12mm but not less.
This servo mount is similar to my original pop up mount but in this case it combines the Popup feature within a complete assembly which fits into a flush mount glued between adjacent wing ribs and is suitable for deeper pockets.
It is designed around the Towerpro 9g SG90 servo.
As with the original mount, if a servo needs to be replaced, or the servo arm needs to be repositioned then it can be tilted up for access.
The whole assembly fits snugly into the mounting frame and the servo can then be replaced by simply removing the 2, M2 clamp screws, tilting the servo assembly upwards and removing the servo.
The pocket depth can be greater than 12mm but not less.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
