MakerWorld
Sport & Outdoors
Zum Modell
9mm Snap Cap Inserts
337
Downloads
69
Likes
145
Makes
Take some used 9mm brass and insert these into it. These require spent brass casings.Any material works, I just used PETG because I had a lot of it in bright red.When inserting these into brass, consider using a hammer to the backside of the brass to make sure they're seated properly, maybe use an adhesive if you want to make sure they don't fall out.Boost MeSupport 3D2A
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
