Thingiverse
Household
Zum Modell
A normal box
414
Downloads
1k
Likes
1
Makes
A normal box with a thread for closure
very resistant and requires approximately a little less than 100g of material. The thread is very good and has a good tolerance ( 0.2mm tolerance\Printer and filament a good calibration is recommended)
Dimensions:
Total height: 85mm
Width: 75mm
Internal height with cap: 61mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Esun PLA+
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
very resistant and requires approximately a little less than 100g of material. The thread is very good and has a good tolerance ( 0.2mm tolerance\Printer and filament a good calibration is recommended)
Dimensions:
Total height: 85mm
Width: 75mm
Internal height with cap: 61mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Esun PLA+
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
